-
flat face + chisel Info: Cross peen used for working in sharp corners around mouldings and for caulking. -
crowned face + curved peen -
crowned face Info: Designed for fenger and high crowned panel dinging or bumping. Both high and low crowned faces for on or off dolly work.
-
crowned face Info: High crowned radius surfaces and short head for close work on concave and recessed panels.
-
crowned face + blurt point
Info: For low spots in high crown panels and other work with small clearance. -
crowned face + square face
-
crowned face Info: For high crown work and finishing, without poking holes in thin sections. It can use on any hard to reach area on inner structure of car
-
crowned face + round point pick
Info: Medium size point an reach for general work.
Low crown strawberry point for perfact balance. -
flat face + chisel Info: Extra wide face are cross grooved and used for shrinkage on large surfaces-vertical chise end used on sharp corners.
-
flat face + milled square face
-
flat face + shrill milled square face
-
crowned face